Normalisation - what it is and how to use it

What is normalisation - what are Peak and RMS normalisation.

Dynamic Processors

Purchase to view this tutorial

By purchasing this tutorial, you'll get immediate access - your purchase helps create new and exciting content and this site survive!

£1.00Add to basket

Normalisation – What it is and how to use it covers in detail what normalisation is and the critical differences between Peak and RMS normalisation. In today’s world of streaming platforms, this process is used to alter uploaded gain values to comply with the streaming platform’s target value.

Normalisation is a digital signal processing function that’s available in a lot of digital audio editing software. It scans through the program material for the highest peak level, and if that level doesn’t reach the maximum available dynamic range, the software boosts the overall signal so that the peak hits the highest level possible. This is referred to as Peak Normalisation. If the audio displays the highest peak value as -3 dB then we need to use peak normalisation to raise that level to 0. This in turns raises all peak transients by the same value.

RMS (Root Mean Square) Normalisation works differently. Instead of using the highest peak value as the reference it now takes all peak values and divides them by the number of peaks. Once this average has been established the process will use the value from this to normalise to 0.

There are a couple of things to be wary of: because the process normalises the whole audio signal it will also raise the noise floor in the process.

If you need to normalise then think carefully about whether to use use Peak or RMS (average level) as each will output a different response.

I tend to find that RMS (Root Mean Square) works best on long audio files that have varying peaks and troughs. Peak tends to work well on single-shot samples, much like drum hits. BUT try both and judge for yourself.

Normalisation still has a part to play in this industry and in particular sound design whereby samples are often truncated and peak normalised to 0. This allows the samples to have a constant value when processing.

What is Normalisation? Should we use it and if so how do we use it correctly? Let me explain in detail how and when you should use this process and whether you should choose Peak or RMS.

The plugin used in this video:

Sound Forge

Topics covered in this video are:

  • What is Normalisation
  • The differences between Peak and RMS
  • Headroom and Ceiling
  • Volume
  • Best Practices

If you found this tutorial helpful then maybe these will also be of benefit:

Topping and Tailing Ripped Beats – Truncating and Normalising

Headroom and Dynamic Range

ISP – Intersample Peaks

Summing in a Mix within your DAW

Shaping Drum Sounds for Layering

The Art of Drum Layering (second edition)

The Art of Drum Layering – Advanced

Low End Compilation